Sanyo DP26670 - Service Mode List

This unit is provided with the following SERVICE MODES so you can repair, examine and adjust easily
.
To enter to the SERVICE MODE function, press and hold both buttons simultaneously on the main unit and on the remot
e
control for more than a the standard time in the appropriate condition. (See below chart.
)
VOL. DOWN
(Minimum)
Initialization of factory TV data.
TV mode 1 2 sec. NOTE: If you set factory initialization, the memories are reset such
as the channel setting, and the POWER ON total hours.
DVD mode
VOL. DOWN
(
No disc
)
(Minimum)
POWER ON total hours are displayed on the screen.
ALL mode 6 2 sec. Can be checked of the INITIAL DATA of MEMORY IC.
Refer to the "WHEN REPLACING EEPROM (MEMORY) IC".
VOL. DOWN Check of the SUM DATA and MICON VERSION on the screen.
(Minimum) Refer to the "WHEN REPLACING EEPROM (MEMORY) IC".
Display of the Adjustment MENU on the screen.
ALL mode 9 2 sec. Refer to the "ELECTRICAL ADJUSTMENT" (On-Screen Display
Adjustment).
Check of the firmware version.
1 2 sec. Refer to the "RE-WRITE FOR DVD FIRMWARE".
NOTE: Do not use this for normal servicing.
DVD mode Releasin
g
of PARENTAL LOCK.
(
No disc
)
Refer to the "PARENTAL CONTROL - RATING LEVEL"
.
STOP 7 2 sec.
VOL. DOWN
(Minimum)
TV mode 8 2 sec.
VOL. DOWN
(Minimum)
DVD mode
(No disc)
STOP
TV mode 0 2 sec. Releasing of V-CHIP PASSWORD.
VOL. DOWN
(Minimum)
4 2 sec. Initialization of factory DVD data.
SERVICE MODE LIS
T
Set
Condition
Set Key
Remocon
Key
Standard
Time
Operations
C-1