Sanyo DP26671 - Signal and Input Labeling; Digital Signal Strength Check; Channel Labeling; Video Input Labeling

1-4: MAIN PCB ASS'Y (Refer to Fig. 1-4)
1. Remove the 6 screws (1)
2. Remove the Plate Jack in the direction of arrow (A).
3.
Remove the Shield Jack in the direction of arrow (B).
4. Disconnect the following connectors:
(CP2804, CP3002, CP3003, CP4201 and CP6201).
5.
Remove the Main PCB Ass'y in the direction of arrow (C).
DISASSEMBLY INSTRUCTIONS
(1)
(A)
(B)
Fig. 1
-
4
(1)
(1)
(1)
(C)
Front Cabi Ass'y
(1)
(1)
Shield Jack
Plate Jack
Mian PCB
Main PCB
B1-2
1-5: POWER PCB / REMOCON PCB / OPERATION PCB
(Refer to Fig. 1-5)
1.
Disconnect the following connectors:
(CP7001, CP7002, CP7003 and CP7004)
.
2.
Remove the 7 screws (1)
3.
Remove the Power PCB in the direction of arrow (A).
4.
Remove the screw (2)
5.
Remove the Operation PCB in the direction of arrow (B).
6. Unlock the 2 supports (3).
7. Remove the Remocon PCB in the direction of arrow (C).
Fig. 1
-
4
Fig.1-5
(1)
Operation PCB
(1)
(1)
(1)
(1)
(1)
(1)
(3)
(B)
(C)
(2)
Power PCB
Remocon PCB
B1-2