Sanyo DP26671 - Video Adjustment and Menu Guide; Video Adjust Menu Options; Quick Guide to DVD Menu Operation

1.
Turn on the power, and set the DVD mode.
2.
Confirm that the "No Disc" will be appeared on the screen.
3.
Insert Up-date disc.
4.
When disc is read normally, Update is started and “Upgrade file DETECTED”
“File Copying” is displayed.
After 5 seconds, displayed words is changed to “Do not power off”, ”UPGRADING” (Black Screen)
(Refer to Fig. 1)
,
then update disc is ejected.
NOTE:
After this, please never turn off AC. If you turn off AC, update fails. When update fails,
update by CD-R can not be carried out after it. Therefore please be careful enough
Upgrade File DETECED
DO not power off
Up-Date of the Firmware
Parts Name
RE-WRITE FOR DVD FIRMWARE
JG176 Up-Date Disc
Ref. No.
JG176
Part No.
APJG176161
SERVICING FIXTURES AND TOOLS
Parts Name
Up-Date Disc
DO not power off
UPGRADING
5.
After the Up-Date, Logo screen will appear.
6.
After update was finished, "Power OFF/ON reset" is carried out automatically
Then, Screen is changed to Logo screen.
7.
Unplug the AC cord, then plug it in.
After the write, set to the initializing of shipping.
8.
Turn on the power, and set the DVD mode.
9.
Press both VOL. DOWN button on the set and Channel button
(4)
on the remote control for more than 2 seconds.
The "Factory Initial Complete" will appear on the screen.
11.
Then unplug the AC cord, and plug it in.
CHECK FOR THE FIRMWARE VERSION
12.
Turn on the power, and set the DVD mode.
13.
Press both Channel button
(1)
on the remote control and the STOP button on the set for more than 2 seconds.
Firmware version will be displayed on the top left of the screen.
F/W Ver. AFJKA1210A
1 2 1 0
Released times on the same date
Release date (Example: 2011.2.10)
Laser drive time
DVD LD : 0Hour
X=October
CD LD : 0Hour
Y=November
Z=December
When the changed version displays, the Re-write will be completed.
14.
Turn off the power
Fixed
A
Fig. 1
A F J K A
C-2