Sanyo DP26671 - V-Chip Parental Control Setup; Password Registration and Management; Setting V-Chip Content Restrictions; Additional V-Chip System Download

2. REMOVAL OF DVD DECK PARTS
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y/LOADER SUB ASS'Y
(Refer to Fig. 2-1-A)
1. Remove the 3 screws (1).
2. Remove the Traverse Ass'y.
2.2:
FEED RACK ASS'Y/GEAR FEED/GEAR MOTOR/
GEAR MIDDLE/FEED MOTOR/PCB630
(Refer to Fig. 2-2-A)
1. Remove the screw (1).
2. Remove the Feed Rack Ass'y.
3. Remove the screw (2).
4. Remove the Gear Feed.
5. Remove the Gear Middle.
6. Remove the Gear Motor.
7. Remove the 2 screws (3).
8. Remove the Feed Motor.
9. Unlock the support (4).
10.
Remove the PCB630.
DISASSEMBLY INSTRUCTIONS
Traverse Ass'y
(1)
Loader Sub Ass'y
Fig. 2-1-C
Check Lock
(1)
(1)
Check Lock
B2-1
10
.
Remove the PCB630
.
• Screw Torque: 3.0 ± 0.3kgf•cm (screw(1))
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
Loader Ass'y (Top side)
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (2))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (3))
Fig. 2-1-A
Fig. 2-1-B
Check Lock
Check Lock
Check Lock
Chassis
Feed Motor
Gear Middle
(2)
Gear Feed
(4)
(1)
PCB630
Feed Rack Ass'y
Gear Motor
Fig. 2-2-A
Check Lock
Check Lock
(3)
(3)
B2-1