VIEWING VIDEO FROM A CAMERA2
18 English
OPERATION
When a monitor 2 is connected to the monitor 2 output
terminal on the digital video recorder’s rear panel, this
monitor can be used to view video from a single camera or
to automatically scroll through video from all cameras,
even if the main monitor is currently displaying video in
split-screen format. In addition, it is also possible to display
video on the monitor 2 automatically from any camera for
which an alarm has occurred. By default, automatic full
screen selection is carried out.
1 Press the [MON2] button.
The MON2 indicator lights up.
z Monitor 2 operation is not possible when a menu screen
is being displayed.
2 Press the No. 4 [CAMERA SELECT]
button.
The video from Camera No. 4 is displayed in full screen
format on the monitor 2.
1 Press the [SEQUENCE] button.
The video displayed on the monitor 2 changes
automatically based on camera numbers.
Press the [SEQUENCE] button once again to cancel
automatic selection.
z If the monitor 2 is not synchronized with the connected
cameras, vertical picture instability may occur upon the
switching of camera video.
1 Set “MON.2 DISPLAY” from <ALARM
OPERATION SET> to “ON”. (JP.74)
When an alarm occurs, the corresponding video is
displayed in full screen format on the monitor 2.
1 Press the [MON2] button.
The MON2 indicator turns off.
z Playback video cannot be viewed on the monitor 2.
Viewing on the monitor 2
Change the monitor 2 setting
Selecting Camera No. 4 for full screen
[MON2] button
MON2
02
03
01
0604 05
04
01-01-04 00:00:00
Monitor 2
Main Monitor
Setting automatic full screen selection
Displaying alarm video in full screen format
Ending the monitor 2 setting procedure
02
03
01
0604 05
04
01-01-04 00:00:00
01-01-04 00:00:00
Monitor 2
Main Monitor
01-01-04 00:00:00
02
MON2
e00_l8hbe_us_7.book Page 18 Friday, April 16, 2004 1:42 PM
To Next Page
Loading...
