GENERAL SET4
84 English
SETTINGS
z Network control is only possible when “NETWORK
CONTROL” has been set to “ON”.
z In order to prevent network control while the digital
video recorder is connected to a network, set
“NETWORK CONTROL” to “OFF”.
The following settings are carried out using the shuttle
dial and jog dial.
z Vertical cursor movement: Turn the jog dial.
z Cursor movement to the right: Turn the shuttle dial
clockwise.
z Modification of values : Turn the shuttle dial clockwise,
and then with the setting value flashing, turn the jog
dial.
z Confirmation of values : Turn the jog dial clockwise.
6 Set “IP ADDRESS”.
(Default setting: 192. 168. 0. 1)
7 Set “SUBNET MASK”.
(Default setting: 255. 255. 255. 0)
8 Set “GATEWAY”.
(Default setting: 0. 0. 0. 0)
9 Set “PORT”.
(Default setting: 00080)
When connecting the digital video recorder to a network,
check the following settings with the network administrator.
z IP ADDRESS
z SUBNET MASK
z GATEWAY
z PORT
Three access levels are setup for network connection, and
a password is set for each. Passwords comprise between
4 and 8 alphanumeric characters.
z “ID” or “PASSWORD (4-8)” at the top of the screen is
the screen title. You cannot move the cursor to this
item.
Example:
Setting “AB123456” to “ID1”
1 Turn the jog dial to select “ID 1”.
[Settings]
2 Turn the shuttle dial clockwise.
The first password entry item “1” flashes.
Characters that can be entered in passwords: 0 to 9, A to Z
Setting passwords for the network
Setting Description Default setting
ID1
Allows video to be monitored via
the network.
1111----
ID2
Allows video to be monitored and
the playback or search/playback of
recordings via the network.
2222----
ID3
Allows all of this recorder’s
operations and settings to be
performed.
3333----
e00_l8hbe_us_7.book Page 84 Friday, April 16, 2004 1:42 PM
To Next Page
Loading...
