COMBI L t
8
Installation
1.
Remove any promotion label from the door.
2.
The oven should be installed on a flat, level surface. The surface must be strong enough to
safely bear the weight (18 kg) of the oven, and the contents. To avoid the possibility of
causing vibration or noise the oven must be in a stable position.
3.
Keep the oven away from heat and water. Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure to install the oven away from heat and
water sources.
4.
Do not block air vents on the top and the sides of the cabinet and also do not place any
articles on the top of the oven. If air vents are blocked during operation, the oven may
overheat, and this may lead to malfunctioning. Hot air escapes from the vents, so be sure
not to obstruct it or let curtains come between the oven and the rear wall.
5.
Place the oven as far away from radios and TV’s as possible. This oven does conform to EEC
requirements of radio interference suppression, but some interference may occur if it is
placed too close to a radio or TV, so keep them as far apart as possible.
6.
If positioned in a corner, leave a gap of at least 5 cm from the walls and 17 cm above the
microwave.
IMPORTANT! The oven can be placed almost anywhere in the kitchen. Make sure
the oven is placed on a flat, level surface and that vents as well as the surface
underneath the oven are not blocked (for sufficient ventilation).
To Next Page
Loading...
