EasyManua.ls Logo

Sanyo EM-X475S - Connecting to the Mains Power

Sanyo EM-X475S
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
t
9
Connecting to the mains
The oven is delivered with the power cord and a plug for 230V, 50Hz, earthed socket outlet.
Earth protection minimises the risks should a short circuit occur. Check to ensure the voltage of
the oven matches the supply.
N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.
This appliance must not be used on a non-earth protected power supply.
Contact an electrician if you are uncertain regarding electrical connection of
the oven or provision of earth protection of the supply.
This appliance must be earthed. If this appliance is fitted with a non-
rewireable plug for which your socket is unsuitable, the plug should be cut off
and the appropriate plug fitted. If it is necessary to change the fuse in a non-
rewireable plug, the fuse cover must be refitted. If the fuse cover is lost or
damaged, the plug must not be used until a replacement is obtained.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
If you fit your own plug, the colours of the wires in the mains lead of your appliance may not
correspond with the markings identifying the terminals in your plug, proceed as follows:
• Connect the green and yellow (earth) wire to the terminal in
the plug which is marked with the letter ”E” or the earth
symbol (
) or coloured green and yellow.
• Connect the blue (neutral) wire to the terminal in the plug
which is marked with the letter ”N” or coloured black.
• Connect the brown (live) wire to the terminal in the plug
which is marked with the letter ”L” or coloured red.

Other manuals for Sanyo EM-X475S

Related product manuals