3 Use your TV
Switching on your TV and putting it in
s
tandby mode
To turn the TV on from standby or off to standby
●
P
ress B on the unit or the remote control.
Note(s)
●
E
nergy consumption contributes to air and water pollution. When the AC power cord is
plugged in, your TV consumes energy with a very low standby power consumption.
Adjusting volume
To decrease or increase volume
●
P
ress VOL J / K on the unit or press VOL + / – on the remote control.
VOL J (–) : Volume down
VOL K (+) : Volume up
To mute or unmute sound
●
Press D on the remote control to mute the sound.
●
Press D again or VOL + / – to recover the original sound.
Switching channels
To select channels by using CHI / H or CH + / –
●
Press CH I (down) / H (up) on the unit or press CH + / – on the remote
control.
To select channels by using the NUMBER keys
●
F
or digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–
W
hen selecting cable or analog channel 11
Press P
REV.CH to return to the previously viewed channel.
Note(s)
●
T
o select the non-memorized channels, use the NUMBER keys.
●
No signal will appear on the TV screen after the subchannel broadcast is over.
●
Audio only program message will appear on the TV screen, when you receive only a sound
signal.
16 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
