-12-
LOCATING THE BEGINNING OF A PROGRAM
(AMSS)
.................................................................... 4, 5, 6
This system is equipped with a function that allows you to skip forward or backward to locate the beginning
of a particular selection on the tape. (Automatic Music Select System : AMSS)
Press the AMSS button
. "AMSS TAPE" is displayed.
Press the FF + button
to skip forward up to 9 selections from the current location on the tape.
e.g.) With "AMSS TAPE" displayed, press button
three times. "AMSS F3" is displayed.
The system will search for 3 blank spaces between selections in the forward direction, then begin
playing the third selection from the starting point.
Press the - REW button
to skip backward to the beginning of the current selection, or up to 8 selections
from the current location on the tape.
e.g.) With "AMSS TAPE" displayed, press button
five times. "AMSS R5" is displayed.
The system will search for 5 blank spaces between selections in the backward direction, then begin
playing the forth selection from the starting point. (The blank space before the current selection
counts as one blank space.)
To cancel AMSS mode, press button
again.
METAL PLAY MODE
................................................. 7
If a metal or high-position tape is used, press the MTL button
to make the player in metal play mode. MTL
is indicated.
SCAN MODE
............................................................ 8
Scan helps to find a program by playing about the first 10 seconds of each selection.
Press the SCN button
during play to start scan operation. "SCn" is displayed.
To cancel scan, press the SCN button
again.
REPEAT MODE
......................................................... 9
This operation makes it possible to listen repeatedly to a selection.
Press the RPT button ➈ during play. "RP" is displayed, the selection playing will continue until RPT is
pressed again.
1
2
3
4
RPT/SCN may not operate properly if
•
A tape was recorded at a low level.
•
A tape has long, silent intervals.
•
A tape is a live recording.
Notes
•
If AMSS detects 15 seconds of blank space, it will automatically advance the tape
to the next selection.
•
AMSS may not operate properly if
•
A tape was recorded at a low level.
•
A tape has long, silent intervals.
•
A tape is a live recording.
Notes
To Next Page
Loading...
