EasyManua.ls Logo

Sanyo HEC-DR5700 - Adjusting Chair Angles: Pre-set and Custom

Sanyo HEC-DR5700
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
ADJUSTMENT OF CHAIR (continued)
Reclining positions change automatically at each press of the button.
(Button illuminates while reclining and flickers when in position)
When switched from BEST POSITION 1 to 2, the foot rest is raised first, and moves to the set angle.
Reclining can be stopped during the reclining motion by pressing either the BEST POSITION button,
HOME POSITION button, RECLINING button, FOOT REST button, OPERATION ON/OFF button, or STOP
button.
When the reclining motion is stopped by pressing the STOP button, press the OPERATION ON/OFF
button to resume the operation.
When the reclining motion is stopped by pressing buttons other than the STOP button, press the desired
button for motion.
When the back rest and foot rest angles are adjusted from the BEST POSITION 2, roller massage can be
selected.
Do not attempt to recline the back rest deeply at first (until the body is accustomed to massaging),
otherwise the massage force may be too strong.
Be sure to check that there are no people (particularly children) or pets around the massager prior to
adjusting the back rest. It may result in an accident or injury.
While massaging the legs, do not attempt to recline the back rest when the legs are squeezed by the air
bags. Do not pull the legs out forcibly, this may result in injury to the legs.
When adjusted at BEST POSITION, the seat is lowered together with the above mentioned movement. (It
is not possible to adjust only the seat.)
For the sake of safety, if the UP ( ) button is pressed with the seat raised, the foot rest may be raised
briefly before going down.
OR
(Remote control) (Sensor controller)
Raise the back rest, and
lower the foot rest by
continuously pressing
the UP ( ) button.
Recline the back rest, and
raise the foot rest by
continuously pressing
the DOWN ( ) button.
NOTE
Adjustment range
Approx. 50°
120°
Adjustment range Approx. 85°
Back rest
Foot rest
5
BEST POSITION 1
Posture suited for whole body massaging
BEST POSITION 2
Posture suited for lower body massaging
BEST POSITION 1
(Slow flickering)
BEST POSITION 2
(Rapid flickering)
Automatically starts massaging in Air
Course (Roller massagecannot be
selected)
Press
Adjust the angle of back rest, foot rest, and the seat.
Press the BEST POSITION button.
Pre-set Angles
Keep the RECLINING button pressed until the desired angle is achieved.
Custom Angles

Related product manuals