Need help?Do you have a question about the Sanyo HT-D47 and is the answer not in the manual?
Details how to connect centre and surround speakers, stressing polarity.
Identifies and describes the function of each button on the HT-D47's front panel.
Step-by-step guide for using Dolby Surround encoded sources, including mode selection.
Instructions for using the test tone to properly adjust centre and surround speaker volumes.
Output Power| centre amplifier power | 15 W (at 8 ohms, 10% distortion) |
|---|---|
| surround amplifier power | 15 W x 2 (at 8 ohms, 10% distortion) |
| maximum power-handling capacity | 30 W (peak) |
Inputs and Outputs| AV1 IN/AV2 IN/AV3 IN audio input | 300 mV/50k ohms |
|---|---|
| AV1 IN/AV2 IN/AV3 IN video input | 1 V P.P/75 ohms |
| LINE IN audio input | 300 mV/50k ohms |
| AV2 OUT audio output | 300 mV/50k ohms |
| PROCESSOR OUT audio output | 1 V/l k ohm |
| AV2 OUT/MONITOR OUT video output | 1 V P-P/75 ohms |
Power| power requirements | AC 230-240 V, 50 Hz |
|---|---|
| power consumption | 70 W |
Speaker Specifications| nominal impedance | 8 ohms |
|---|---|
| unit used | Full range: 10 cm cone type |
Weight and Dimensions| centre speaker dimensions | 270(W) x 80(H) x 320(D) mm |
|---|---|
| centre speaker weight | 3.7 kg |
| surround speaker dimensions | 270(W) x 130(H) x 140(D) mm |
| surround speaker weight | 1.6 kg |
| other speaker dimensions | 170(W) x 130(H) x 107(D) mm |
| other speaker weight | 1 kg (per speaker) |
To Next Page
