Sanyo Katana II - Pairing Bluetooth Devices

138 Section 2J: Using Bluetooth
Pairing Bluetooth Devices
Paired Devices
The Bluetooth pairing process allows you to establish trusted connections
between your phone and another Bluetooth device. When devices are
paired, a passcode (sometimes called a PIN) is shared between devices,
allowing for fast, secure connections while bypassing the discovery and
authentication process.
To pair your phone with another Bluetooth device:
1. Press > Tools > Bluetooth > Add New > Search.
(Your phone will display a list of discovered in-range Bluetooth
devices.)
2. Select the device you wish to pair with and press .
3. Select Add to Trusted.
4. Enter the PIN and press . (When the owner of the other device
enters the same PIN, the pairing is complete.)
Waiting for Request
If you are going to be using a Dial-Up Network (DUN) profile to pair with a PC
or PDA, you will need to allow the other device to initiate pairing with your
phone.
To allow your phone to be paired with another Bluetooth device:
1. Press > Tools > Bluetooth > Add New > Wait for Request.
2. Follow the onscreen prompts to enter your PIN and press .
Note:
If Bluetooth is not enabled on your phone, you will be asked to enable it
before you can proceed with the pairing process.