Section 2A: Phone Basics 35
Dialing From the Contacts List
To dial directly from a Contacts entry:
1. Press > Contacts > Find/Add Entry.
2. Highlight the entry you want to call and press to dial the entry’s
default phone number.
– or –
To dial another number from the entry, highlight the name and press
, and then highlight the number you wish to call and press .
Using Speed Dialing
With this feature, you can dial your favorite entries using one keypress for
locations 2–9. (See “Assigning Speed Dial Numbers” on page 92.)
To use speed dial :
䊳
From standby mode, press and hold the appropriate key for
approximately two seconds. The display confirms that the number
has been dialed when it shows “Connecting...”.
Note:
Speed dialing may not be available when you are roaming; when you
are roaming off the home network, you must always dial using 11 digits
(1 + area code + number).
Shortcut:
From the standby mode, press
Contacts
(right softkey) to display
the Contacts list.
Phone Basics
To Next Page
Loading...
