FOR SAFE AND EFFICIENT OPERATION
1
The apparatus shall not be exposed to dripping or
splashing.
Do not damage the mains lead.
When not in use, disconnect the mains lead from the
outlet. Grasp the plug, not the cord, when disconnecting
the unit.
If water should enter the unit, electrical shock or a
malfunction may result. Use in an area where there is
low humidity and little dust.
Do not disassemble or alter the unit in any way.
Do not use the unit in areas where extremes in tempera-
ture occur (below 5°C or exceeding 35°C), or where it
may be exposed to direct sunlight.
Because of the CD player’s extremely low noise and
wide dynamic range, there is a tendency to turn the
volume on the amplifier higher than necessary. Doing
so may produce an excessively high output from the
amplifier which can cause damage to your speakers.
Please be careful in this regard.
Sudden changes in the surrounding temperature can
cause dew to form on the optical pickup lens inside the
unit. Under this condition the unit may be unable to
operate properly. If this should occur, remove the disc
and allow the player to adjust to the surrounding tem-
perature:
1
Important Notes:
1) When positioning the unit for use, be sure to place it
on a flat surface so that it does not tilt.
2) When carrying the unit from one location to
another ...
- When moving the unit a short distance, such as
from room to room, turn the power off and wait
at least 10 seconds for the CD changer mecha-
nism to reset.
- Lift the unit by the handle and besureto keep the
unit in a horizontal position.
3) When transporting the unit ...
- Remove all the discs from the unit.
Carrying the unit around with discs inside can
cause damage to the discs and may cause the
unit to malfunction.
- Press the POWER button to turn off the power
and wait at least 10 seconds for the CD changer
mechanism to reset before carrying the unit.
WHAT TO DO IF ...
If “CH Err” appears on the display.
1. Press the POWER button to turn the power off.
2. Press the POWER button to turn the power on.
If the operation of the unit or display is not normal,
even though the appropriate buttons have been
pressed.
1. Disconnect the AC mains lead and remove the batter-
ies (if applicable).
2. Press the RESET button (rear of the unit) for at least
20 seconds. (See Page 5.)
3. Connect the AC mains lead and install the batteries
(if applicable).
4. Press the desired function button.
NOTE:
Ifthe unit does not operate correctly, or”CH Err” appears
again, please contact your nearest Sanyo Authorized
Service Center.
-2-
To Next Page
Loading...
