Sanyo PID-42NE1 - Power on; off

Power Indicator
Remote Control Sensor
Power switch
13
Power On / Off
Press the button on the remote control to turn the Display off.
Power Indicator: Red (standby)
Press the button on the remote control to turn the Display on.
Power Indicator: Green
Turn the power to the Display off by pressing the switch on the unit, when
the Display is on or in standby mode.
Note:
During operation of the power management function, the power indicator turns
orange in the power off state.
Connecting the plug to the Wall Outlet
Notes:
• Main plug types vary between countries. The power
plug shown at right may, therefore, not be the type
tted to your set.
• When disconnecting the AC cord, be absolutely
sure to disconnect the AC cord plug at the socket
outlet rst.
Press the Power switch on the Display to turn the
set on: Power-On.
Power Indicator: Green
Connecting the AC cord plug to the Display.
Announcement
The main unit radiates heat and some of the parts may become hot. This is not a problem for performance
or quality. Set up in a location with good ventilation. Do not cover the ventilation holes of the Display with a
tablecloth, etc., and do not place on top of other equipment.