Sanyo PID-42NE1 User Manual

3D Y/C Filter (NTSC)
Colour system
Signal
On
Auto
Cinema reality
Off
4:3
[
AV
]
Noise reduction
Off
39
Press to select “Noise reduction”.
Press to select “Off”, “Auto”, “Min”, “Mid”, “Max”.
Auto: Noise reduction will be automatically selected from “Min”,
“Mid” or “Max”.
Noise reduction
Setup for Input Signals
Note:
Noise reduction can be adjusted while a Video or Component signal is being applied.
Sync
Signal
H-Freq.
V-Freq.
kHz
Hz
63.98
60.02
Signal Format
1280×1024/60
[
RGB
]
Cinema reality
Noise reduction
XGA Mode
Auto
Off
Off
1024
× 768
This function operates only during input from PC IN terminal.
Select Signal from the “Setup” menu during Component input signal.
Conrm that the input is set to RGB input (this setting is valid only for RGB input signal).
Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
However, the synchronized signal that is input rst is selected.
on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
Note:
Accepts only RGB signals from COMPONENT/RGB IN terminal with “Sync on G”
Sync
Press to select the “Sync”.
Press to adjust.

Sanyo PID-42NE1 Specifications

General

Brand	Sanyo
Model	PID-42NE1
Category	Monitor
Language	English