Model Combinations
Combine indoor and outdoor units only as listed
below.
Indoor Unit Outdoor Unit
Power Source:
50 Hz, single-phase, 220 – 240 VAC
Combinations of indoor and outdoor units
Connect indoor and outdoor units only in the
combinations listed in the catalog or installation
manual.
Connecting any other model may result in
operation failure and system damage.
Español
Français Deutsch Italiano
Português
EEÏÏÏÏËËÓÓÈÈÎο¿
English
85264190441000 © SANYO 2008 SANYO Electric Co., Ltd.
Osaka, Japan
Contents
Page
IMPORTANT!
Please Read Before Starting .................................. 2
1. GENERAL .......................................................... 3
1-1. Tools Required for Installation (not supplied)
1-2. Accessories Supplied with Unit
1-3. Optional Copper Tubing Kit
1-4. Type of Copper Tube and Insulation Material
1-5. Additional Materials Required for Installation
2. INSTALLATION SITE SELECTION ................... 4
2-1. Indoor Unit
2-2. Embedding the Tubing and Wiring
3. HOW TO INSTALL THE INDOOR UNIT ............ 6
3-1. Remove the Rear Panel from the Unit
3-2. Make a Hole
3-3. Install the Rear Panel on the Wall
3-4. Removing and Installing the Grille
3-5. Shape the Indoor Side Tubing
3-6. Wiring Instructions
3-7. Wiring Instructions for Inter-unit Connections
3-8. Mounting
3-9. Drain Hose
4. MULTIPLE SWITCH ON THE REMOTE
CONTROL UNIT INDOOR UNIT TYPES
(SAP-KRV184EH, KRV244EH)
(SAP-KRV186EH, KRV246EH)
(SAP-KRV96EHDS) .......................................... 19
5. HOW TO TEST RUN THE AIR CONDITIONER ... 20
6. REMOTE CONTROL UNIT INSTALLATION
POSITION ......................................................... 22
6-1. Mounting on a Wall
7. ADDRESS SWITCH.......................................... 23
7-1. Address Setting of the Remote
Control Unit
8. CONNECTING A HOME AUTOMATION
DEVICE.............................................................. 24
9. INSTALLATION CHECK SHEET ...................... 24
INSTALLATION INSTRUCTIONS
– Inverter Split System Air Conditioner –
COOL/DRY/HEAT Model
This air conditioner uses the new refrigerant R410A.
Be sure to read the yellow instruction sheet
attached to the outdoor unit for models using the
new refrigerant R410A.
The illustrations are based on the typical appearance
of a standard model. Consequently, the shape may
differ from that of the air conditioner that you are
installing.
To Next Page
Need help?
General
