EasyManua.ls Logo

Sanyo SAP-CMRV1426EH - 6 Remote Control Unit Installation Position; Mounting on a Wall

Sanyo SAP-CMRV1426EH
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
English
6. Remote Control Unit Installation Position
The remote control unit can be operated from either a
non-fixed position or a wall-mounted position.
To ensure that the air conditioner operates correctly,
do not install the remote control unit in the following
places:
G In direct sunlight
G Behind a curtain or other place where it is covered
G More than 8 m away from the air conditioner
G In the path of the air conditioner’s airstream
G Where it may become extremely hot or cold
G Where it may be subject to electrical or magnetic
interference
G Where there is an obstacle between the remote
control unit and the air conditioner (since a check
signal is sent from the remote control unit every 5
minutes)
6-1. Mounting on a Wall
Before mounting the remote control unit, press the
ON/OFF operation button at the mounting location to
make sure that the air conditioner operates from that
location. The indoor unit should make a beeping
sound to indicate that it has received the signal.
Hole
Remote control unit mount
Mounting screws
4 × 16 (included)
Rear side
Press
Set in
place
To prevent loss of the remote control
unit, you can connect the remote
control unit to the mount by passing
a string through the remote control
unit and attachment hole.
Fig. 61
To take out the remote control unit, pull it forward.
07-370 CMRV3146EH_IU ENG 2/6/08 1:31 PM Page 22

Other manuals for Sanyo SAP-CMRV1426EH

Related product manuals