Remote Control Unit (continued)
TIMER ON button : The air conditioner starts at the set time.
TIMER OFF button
: The air conditioner stops at the set time.
TIMER SET button This button is used to set the time at which you wish the air
conditioner to go on or off.
MODE selector button
(AUTO)
(HEAT)
(DRY)
(COOL)
Use this button to select AUTO, HEAT, DRY or COOL mode.
: When this setting is selected, the air conditioner calculates
the difference between the thermostat setting and the room
temperature and automatically switches to the ‘‘COOL’’ or
‘‘HEAT’’ mode as appropriate.
: The air conditioner makes the room warmer.
: The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
FLAP button Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
NOTE
To switch to the sweep function ( ) when in the manual ( ) mode,
hold down the FLAP button.
FAN SPEED selector
button
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
1 HR. TIMER button
(1-HOUR OFF TIMER)
1HR.
: When you press this button, regardless of whether the unit is
operating or stopping, the unit operates for one hour and
then shuts down.
ACL button
(ALL CLEAR)
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
•
Automatic switching between cooling and heating
This unit automatically switches between cooling operation and heating operation according to the
difference between the room temperature and the temperature setting.
9OI-332-09EG
oi332000
To Next Page
Loading...
