To Next PageTo Next Page
Need help?Do you have a question about the Sanyo SAP-K71GJA and is the answer not in the manual?
General| Cooling Capacity | 7.1 kW |
|---|---|
| Heating Capacity | 8.0 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Type | Split System |
Provides wiring diagrams for indoor units, showing connections for controller, fan motor, and sensors.
Provides guidelines for selecting installation locations for indoor and outdoor units, including safety and operational considerations.
Provides initial checks for power supply, wiring, and connections before diagnosing issues.
Troubleshooting steps for when the air conditioner fails to operate, including circuit breaker issues.
Diagnoses and resolves issues related to tripped circuit breakers or blown fuses.
Troubleshoots scenarios where neither the indoor nor the outdoor unit powers on.
Addresses troubleshooting for specific components like fans or compressors not operating.
Diagnoses and resolves issues when only the indoor fan fails to operate.
Troubleshoots scenarios where only the outdoor fan fails to operate.
Troubleshoots issues where the compressor does not run, checking for potential causes.
Guides on diagnosing and resolving observed abnormalities during air conditioner operation.
Troubleshoots and resolves issues related to inadequate cooling performance.
Guides on identifying and resolving problems caused by defective temperature sensors (thermistors).
Troubleshoots a defective indoor coil temperature thermistor (TH1), including alarm signals.
Diagnoses issues with a defective room temperature thermistor (TH2), covering open and short circuits.
