To Next PageTo Next PageWhat to do if my Sanyo Air Conditioner has power supply issues?
If your Sanyo Air Conditioner is not working, verify that the voltage is within the specified range (±10% of the rating). Also, ensure that power is being supplied to the unit.
General| Brand | Sanyo |
|---|---|
| Model | SAP–K302A |
| Category | Air Conditioner |
| Language | English |
Essential instructions and precautions for safe installation and operation of the air conditioning system.
Critical safety instructions for electrical wiring to prevent severe injury or death.
Important cautions regarding ventilation, refrigerant gas hazards, and fire risks.
Detailed specifications for major components of the indoor unit, including fan motor, flap motor, and heat exchanger coil.
Detailed specifications for major components of the outdoor unit, including compressor, fan motor, and heat exchanger coil.
Important guidelines on insulating refrigerant tubing to prevent heat loss and condensation damage, with minimum thickness requirements.
Describes the function that prevents the indoor heat exchange coil from freezing by cycling the compressor off when temperatures drop below a threshold.
Troubleshooting for circuit breaker trips and ground faults when the air conditioner fails to operate.
Diagnostic steps for when neither the indoor nor outdoor unit runs, covering power, remote control, and internal components.
Troubleshooting steps when only the outdoor unit does not run, checking temperature settings and power relay.
Steps to diagnose why the indoor fan is not running, including checking rotation, motor winding, and capacitor.
Steps to diagnose why the outdoor fan is not running, including checking rotation, motor winding, and capacitor.
Diagnostic steps for when the compressor fails to run, checking capacitor, winding resistance, power relay, and refrigerant shortage.
Procedure to troubleshoot the flap motor not running by measuring its winding resistance.
Troubleshooting steps for when the outdoor fan speed control function is not working, checking PCB and air sensor.
Steps to diagnose poor cooling, including checking remote position, tube insulation, temperature difference, and air filter.
Detailed steps for measuring insulation resistance of power supply wires, indoor unit, outdoor unit, and individual electrical parts.
Method for checking the continuity of a fuse on the PCB assembly using a multimeter.
Procedure for checking the condition of motor capacitors (compressor and fan) by observing multimeter pointer response.
