Using the Remote Control Unit (continued)
Mounting the Remote
Control Unit
When attaching to wall 1) Confirm the indoor unit beeps when the ON/OFF button is pressed at
the wall location where the remote control unit is to be attached,
then attach the holder to the wall.
2) When taking out the remote control unit, pull it from the holder.
When using the remote
control unit
•
Point the transmitter on the remote control unit at the sensor on the
indoor unit when operating the remote control unit and the air
conditioner.
•
Do not place objects which may block the transmitted signals
between the receiver and the remote control unit.
Securing the remote
control unit to prevent
theft
1) Attach the holder to the wall with one screw in the upper hole only.
2) Remove the cover from the remote control unit, and then remove
the batteries. Next, place the remote control unit in the holder.
3) Secure both the remote control unit and the holder to the wall with
another screw through the lower hole.
4) Put the batteries back in the remote control unit, and then replace
the cover.
Remote
control
unit holder
Truss-head
tapping screws
4 x 16 mm (supplied)
Press
Hook
Holder
Holder
Truss-head
tapping screws
4 x 16 mm (supplied)
Remote
control
unit holder
11OI-396-11EG
oi396000
To Next Page
Loading...
