Sanyo SAP-KRV94EHDX - Page 31

Hook
Ta b
Electrical
component box
Electrical component box
Hook
Ta b
Electrical component box
Electrical component box
pad plate 3
Electrical component
boxpad plate 2
Indicator lamp
Electrical component
box cover
Remove these two tabs and
lightly expand the electrical
component box cover, and the
remaining tab can readily be
removed.
(3) Removing the electrical component box.
(3-1) Slightly expand the side of the main body to the
right side and unhook the tabs.
(3-2) Holding the bottom of the electrical component
box while keeping the main body as it is in (3-1)
above, release the tab at the top of the electrical
component box.
(4) Removing the P.C.Board
(4-1) Remove the indicator lamp, electrical component
box pad plates 3 and 2.
(4-2) Remove the electrical component box cover.
To replace the panel motor, proceed to
"8-4. Removing the Panel Motor".
NOTE
31