3-37
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
3. Timer Remote Controller
Duplicating the Program Timer
You can duplicate the preset program by day.
Select the copy source.
1. If is pressed in program checking mode , it enters
the copy mode (Selecting the copy source
) of the pro-
gram timer.
While in the copy mode of the program timer, and
(day) of the copy source fl ash on the display.
2. Press
/ to select the day of the copy source.
Select the copy destination.
3. If
is pressed in the mode of selecting the copy source
, it enters the copy mode (Selecting the copy destina-
tion ) of the program timer.
4. Press
/ to select the day of the copy source.
Then, press
to complete copying and return to the
program checking mode.
NOTE
The program will be overwritten if the preprogrammed day is selected as a copy source.
Before Asking Repair Work
Before asking repair work, please check the followings.
Trouble Possible Cause/Remedy
“ERROR” is displayed when the
minute digits are entered.
If there is another TIMER No. which has the program of the same time and same day, you cannot overlap the
setting.
The set data is not stored. The stored programs are automatically sorted by the time. Check if the data is stored in the other TIMER No.
Program does not function.
Check if the time indication is not “– – : – –”.
When the time is invalid, the program is also invalid.
Check the remote controller prohibition inside.
In that case, the program is invalid.
Weekly Program Function (Continued)
3,51 2,4
TD831143-00W-3WAY.indb37TD831143-00W-3WAY.indb37 2008/12/0110:26:332008/12/0110:26:33
To Next Page
Loading...
Need help?
General
