Need help?Do you have a question about the Sanyo TP1005 and is the answer not in the manual?
General| Drive method | Belt Drive |
|---|---|
| Speeds | 33 1/3, 45 RPM |
| Platter | Aluminum die-cast |
| Motor | DC Servo Motor |
| Tonearm type | Static balanced pipe arm |
| Cartridge weight range | 4 to 6 g |
| Tonearm | Static balanced type |
Adjust the tone arm lever to make its protrusion contact the foremost end.
Position the micro-switch for correct turntable start when the tonearm heads toward the center.
Set auto-return by adjusting a shaft when the stylus reaches a specific point from the turntable center.
Ensure the headshell is not inclined left or right and the stylus is normal to the record.
Set cuing lever to UP and adjust arm lifter screw for 9mm stylus-to-record clearance.
Adjust spring tension for 11mm stylus-to-record clearance after auto-return.
Adjust speed control dials and check with strobe marks for stationary appearance.
To Next Page
