Sanyo VHR-1110 Series - Page 10

1-5-4. From STOP mode to F-FWD mode
(See Fig. 1-5-1, Table 1-5-4)
When the FF button is pressed during the STOP mode, the
mode changes to the F-FWD mode. The movement of the
main gear at this time is as described below.
As a result of the movement of the sub slide in Fig. 1-5-1 in
the direction of arrow G), the FF lever is caused (by the
hook of the sub slide) to move in the direction of sub slide
@.
Direct lever to be moved in the
perpendicular up direction @
Review gear
button is pressed.
Mode Detect SW chs @)
Head Motor
Capstan Motor
Tape Loading Motor
Main brake
Soft brake
Direct Lever
F-FWD
(REW)mode
The
spring
located
between
the
FF
lever
and
the
direct
lever
is
thus
caused
to
be
pulled,
causing
the
direct
lever
to
be
moved
in
the
perpendicular
up
direction,
with
the
result
that
the
main
gear
@)
is
driven
directly.
At the same time, the review gear is caused to move away
from the main gear, with the result that the main gear
rotates at high speed.
F-F Lever
Q+—
Sub slide
Main slip gear
STOP mode
' .
psec
ON
FE
(Supply
reel
base
side)
—(OFF
)
|
(OFF
|
i
Loading brake
|
|
|
Main brake on
(Take-up reel base side)
|
Soft brake
(Take-up reel base side) —{orF )
oN }-—
Review brake
——{ OFF oe
|
sa cg aaa
!
Table 1-5-4 Timing chart of from STOP mode to F-FWD (REW) mode