- 22 -
English language
EN
• At the end of the working day remove the plug from the power socket.
• Clean thoroughly using neutral products.
• Wash the outer part of the machine using a damp sponge.
• Do not use steel wool or abrasive pads.
• Dismantle the mincer set and wash using suitable detergents in hot water or in the dishwasher.
If the machine is to be left idle for long periods of time, turn off the main wall switch, thoroughly
clean the machine and cover it with a sheet to protect it from dust.
Check for the perfect efciency of the plant grounding system. Make sure that the line voltage
and the frequency correspond to the machine ratings (refer to the machine identication
plate and wiring diagram). The machine comes equipped with an electric cable to which a
multipolar plug should be connected. Plug the machine into a main wall switch with differential.
Start the machine for just a few second and check that the beater turns in the right direction. If
this is not the case, disconnect power and exchange two of the three phase wires in the plug.
To Next Page
Loading...