Software Handshake
The software handshake is controlled via XON and
XOFF. When a device is switched on, XON must
be transmitted to enable any connected device to
communicate.
Activating Data Output
You can define the data output parameter so that
output is activated either when a print command
is received or automatically and synchronously with
the balance/scale display (see application program
descriptions and auto-print setting).
Data Output by Print Command
The print command can be transmitted by pressing
p or by a software command (Esc P).
Automatic Data Output
In the “auto print” operating mode, data is output
to the interface port without a print command.
You can choose to have data output automatically
and synchronously with the balance/scale display
at defined print intervals with or without the
stability parameter. Whichever parameter you
select, the data will be output as the readouts
appear on the balance/scale display. The display
update frequency depends on the setting for
“Adapting the Filter” (code 1.1.+.).
When the “auto print” menu code is activated, this
function starts immediately after the balance/scale
has been turned on.
11
To Next Page
Loading...
