Leveling the Balance/Scale
Purpose:
– To compensate for unevenness at the place of
installation
Always level the balance/scale again any time after
it has been moved to a different location. Only the
2 front feet are adjusted to level the balance/scale.
§ Retract the two rear feet (only on models with
a rectangular weighing pan).
§ Turn the 2 front feet as shown in the diagram until
the air bubble is centered within the circle of the
level indicator.
> In most cases this will require several adjustment
steps.
§ On models with a rectangular weighing pan: extend
the 2 rear feet until they touch the surface on which
the balance/scale rests.
Anti-theft Locking Device
§ To secure the balance/scale at the place of
installation, fasten a chain or a lock to the lug
located on the rear panel of the balance/scale.
10
To Next Page
Loading...