The weight display shows the following special codes
for your information:
OFF
The balance was disconnected from AC power
(i.e., power failure or outage; the balance
was disconntected, then reconnected to AC power).
O (STANDBY)
The display has been turned off using the e key (14),
and the balance is now in the ready-to-operate mode
and does not require warmup.
b (BUSY)
Once you have turned on the balance, the b symbol
will remain displayed until you press a key. During
operation, this symbol indicates that the balance
processor is still busy processing a given function and
will not accept another command to perform any
other function at this time.
R1 or R2
The number in the R code identifies the particular
weighing range you have selected.
W
Symbol for the selected application (in this case, the
weighing mode).
CAL I
The balance has an internal calibration weight.
1–15
To Next Page
Loading...
Need help?
General