Sartorius ME215S - Application 1 Settings - Counting; Application 1 Settings - Percent weighing; Application 1 Settings - Animal weighing (averaging); Application 1 Settings - Recalculation

Setup – Application 1 Counting Accuracy – Average ο Display accuracy
Application (Basic settings) piece weight calculation + 1 decimal place
parameters (resolution) + 2 decimal places
Average piece Off
weight updating Manual
ο Automatic
Percent weighing Weight storage accuracy ο Display accuracy
(resolution) + 1 decimal places
+ 2 decimal places
Decimal places for None
readout in percent 1 decimal place
ο 2 decimal places
3 decimal places
4 decimal places
5 decimal places
6 decimal places
7 decimal places
Display calculated value ο Residue
Loss
Ratio 1 (DR)
Ratio 2 (OR)
Animal weighing* Animal activity Calm
(averaging) Normal
Active
0.1% of the animal/object
0.2% of the animal/object
0.5% of the animal/object
1% of the animal/object
2% of the animal/object
ο 5% of the animal/object
10% of the animal/object
20% of the animal/object
50% of the animal/object
100% of the animal/object
Start Manual mode
ο Automatic mode
Minimum load for automatic None
storage 10 digits
20 digits
50 digits
ο 100 digits
200 digits
500 digits
1000 digits
Decimal places in None
result display 1 decimal place
ο 2 decimal place
3 decimal places
4 decimal places
5 decimal places
6 decimal places
7 decimal places
Printout None
ο Average weight only
Average and calculated value
Recalculation*
For calculation through air buoyancy correction, see following pages
Applications 2 and 3 see following pages
* = How to run this application is described in detail in our Masterpro “LA….” Installation and Operating Instructions.
Request your copy directly from Sartorius or download it from the Internet (www.sartorius.com; see “download”)
28
Factory setting