Sartorius QC15DCE-S - Utilities and Output Configuration

Auto tare when
S/a is pressed 6 4 3
Output of Application
Parameters Code
Off 7 1 1*
All parameters 7 1 2
Data ID Code Code
Without 7 2 1
With 7 2 2*
Auto output of the tare
memory data Code
Last net value 7 3 1*
Tare memory data (total) 7 3 2
Data Output with Time
+ (ID) Code
No output 7 4 1
Output date & time 7 4 2
Output article ID no. 7 4 3
Output article no.,
date & time 7 4 4*
(only with YDP03-0CE)
* = factory setting
Utilities
Data output Code
W/out stability 6 1 1
After stability 6 1 2*
At stability 6 1 3
Auto w/o stability 6 1 4
Auto after stability 6 1 5
Autoprint Code
Stop/start using key 6 2 1
Not stoppable 6 2 2*
Autoprint interval after Code
1 display update 6 3 1*
2 display updates 6 3 2
5 display updates 6 3 3
10 display updates 6 3 4
20 display updates 6 3 5
50 display updates 6 3 6
100 display updates 6 3 7
Automatic Tare Code
No automatic taring 6 4 1*
Auto tare when
p/p is pressed 6 4 2
Record Header (Your Co. Name)
Output of header lines 1 and 2
Code
No output 7 5 1
Output 1st header line 7 5 2
Output 2nd header line 7 5 3
Output both header lines 7 5 4*
Output of “wRef” and “nRef”
Output: in record/printout Code
No output 7 6 1
Piece count “nRef” 7 6 2
Avg. piece weight “wRef” 7 6 3
Piece count “nRef” and
piece weight “wRef” 7 6 4*
Output: Net/Tare/Gross/
Counting Result
Output: in record/printout Code
Net value or piece count 7 7 1
Net val. and piece count 7 7 2
Net/tare comp./gross
or counting result 7 7 3
Net/tare comp./gross
and counting result 7 7 4*