Sartorius Secura 6101-1S - Display Brightness; Acoustic Signal

38
System Settings (Setup Menu)
User Manual Secura
®
, Quintix
®
, Practum
®
2) Connection with Sartorius lab printer via the supplied printer cable
Device / Protocol menu option:
t Select the desired setting for connection to the printer.
– YDP30 | YDP40: The connected printer is automatically detected and the
connection is established.
– Off: The connection to the printer is deactivated.
3) and 4) Connection to a serial printer or another external serial device via a
9-/25-pin serial interface (USB MiniA for RS-232)
Device / Protocol menu option:
t Select the desired setting for connection to the device.
– Printer YDP20-0CE
– Second display YRD03Z
– USB-RS-232 SBI
– USB-RS-232 xBPI (Secura
®
and Quintix
®
only)
–
Off: The connection is deactivated.
RS-232 Configuration menu option:
This option can be selected by going to Device / Protocol and choosing the
USB-RS-232 SBI setting.
t Select the desired setting for the RS-232 interface.
– Baudrate: 600 to 19,200 (factory setting: 9600)
– Databits: 7 Bits or 8 Bits (default: 8 Bits)
– Parity: Odd, Even, or None (default: Odd)
– Stopbits: 1 Bit or 2 Bits (default: 1 Bit)
– Handshake: Software (XON, XOFF), Hardware (CTS, RTS), or Off
[default: Hardware (CTS, RTS)]
6.2.9 Display Brightness
Display brightness
Eco mode
Medium
Bright
Set the display brightness here.
The following brightness levels are available:
– Bright
– Medium
– Eco mode: energy-saving mode (default). Brightness is reduced after two
minutes of inactivity. Press any key to return to normal brightness.
6.2.10 Acoustic signal
Acoustic signal
Medium
Low
Loud
Off
Set the volume of the acoustic signal here.
The following volume levels are available:
– Loud
– Medium
– Low
– Off