29
Installation
Wall mount (dose – socket)
First, remove the back of the thermostat. Do that by
using a straight screwdriver and carefully rise the
front cover from the bottom up. While doing that you
will notice a small flex cable attached to the back
and the front of the case. Be careful not tearing it.
You have to remove the cable from the front part of
the case. Do it carefully. Now, the thermostat
should be separated on two parts – front (screen)
and back (electrical connection…).
When the parts are separated, take the back part and make the electrical
wiring.
Once again, the assembly should be carried out by a qualified person and
read all safety instructions and warnings before assembly. Keep main power
off all the time!
Use the electrical wiring scheme on the right side for help.
To Next Page
Loading...
