Satel PK-01 - Using the Module; Unlocking the Door; Blocking the Door; Restoring Normal Operation

SATEL PK-01 3
5. Using the module
5.1 Unlocking the door
5.1.1 Unlocking the door with identifiers
Bring the card close to the module (to a distance allowing the card to be read) or enter the
code and confirm it with the key to start the procedure of user verification. Having
identified the user, the module will signal the door unlocking with a short beep. The relay will
activate for a preset time during which the door opens freely. Depending on the module
settings, the relay operate time after opening / closing the door can be shortened. The door
should be closed before expiry of the maximum door open time.
The door will remain locked if the card or the code is unknown (2 long beeps) or the door is
blocked (2 long beeps and the yellow LED is lit up).
5.1.2 Unlocking the door without user identification procedure
The door can be unlocked using the request-to-exit button/device. Using it will cause the
same response of the module, as in case of the user identification based on the card or code.
5.2 Blocking the door
The door can be blocked (permanently locked) by the user authorized to block / unblock the
door.
Note: The user can only block the door when the door status is being monitored (see the
"Programming the door status input" function).
In order to block the door, do the following:
1. Make sure that the door operates in normal mode and the door is closed.
2. Place the card in proximity of the module and hold it for about 4 seconds or enter the
code and confirm with the key. The device will confirm with 2 short beeps that the door
is blocked. The yellow LED will light up.
5.3 Restoring the door to normal operation mode
The blocked / unblocked door can be restored to its normal operating mode by a user
authorized to block / unblock the door. It can be done using a proximity card or code.
In order to restore the normal operating mode of the door, place the card in close to the
module and hold it for about 4 seconds or enter the code and confirm with the key. The
device will signal restoration of the door to the normal operating mode by 2 short beeps.
5.4 Unblocking the door
The door can be unblocked (permanently unlocked) by the user authorized to block / unblock
the door.
Note: The user can only unblock the door when the door status is being monitored (see the
"Programming the door status input" function).
In order to unblock the door, do the following:
1. Make sure that the door operates in normal mode and open the door.
2. Place the card in proximity of the module and hold it for about 4 seconds or enter the
code and confirm with the key. The device will confirm with 2 short beeps that the door
is unblocked.