2.6.2 Upgrade by Using the Web Management System
Copy the firmware to the controller or phone and use Wi-Fi to connect it to the receiver. The name of the Wi-Fi
is the device’s S/N. Then, input 192.168.20.1 to log in, click Firmware upgrade - Select - File to choose the
firmware, and then click start to transfer the new firmware version.
2.7 AR Stake
SL7 supports AR stakeout function. The iHand55 controller and the software Satsurv V3.0.2 or later versions are
required.
The AR stakeout scene is defined as when the stakeout point is approximately 3m from the receiver, the
camera of the receiver is called, and the precise position of the stakeout point is displayed in real time through
the controller.
2.7.1 AR Stake Instructions
1. Device Preparation
Preparation before AR stakeout:
(1) Use the iHand55 controller to connect the SL7 via WIFI;
(2) The receiver has entered the tilt survey mode;
(3) The solution state is fixed solution.
2. Stakeout Process
After entering the point stakeout interface:
(1) Input the stakeout point;
(2) Click the AR stakeout button ;
(3) Complete the prompts for the stakeout;
(4) The stakeout is successful.
Click the AR stakeout button, when the distance from the stakeout point is > 3m, use the control AR stakeout
(control navigation); if the distance from the stakeout point is less than or equal to 3m, switch to the AR stakeout
(receiver navigation).
Notice:
1. When the download fails, it will resume downloading if the network recovers within two
minutes; otherwise, it will exit the firmware upgrade detection.
2. It will not forcibly power off during the upgrade. If the power is forcibly cut off, the instrument
may be damaged and become abnormal.
To Next Page
Loading...
