What does ERROR: OCCURRED: CLEARING QUEUES Please Wait mean on SATO GL412e Barcode Reader?
The SATO Barcode Reader displays 'ERROR: OCCURRED: CLEARING QUEUES' as an interim message while the printer discards host data it cannot use because a fault condition exists. While the message displays, the asterisk (*) rotates. Wait. When the asterisk (*) stops rotating, a different fault message will appear. Troubleshoot the final message.
What causes GAP NOT DETECTED error on SATO GL412e Barcode Reader?
The SATO Barcode Reader displays 'GAP NOT DETECTED' because the printer is set for Gap or Mark sensing, but a black mark is not being detected. Ensure the Gap/Mark Sensor setting in the SENSOR SETUP menu matches the installed media. Ensure the sensors are properly positioned. Clean the sensor assembly and paper path. Run Auto-Cal to improve the sensor’s ability to detect the media in use. Run the Media Profile printout in the SENSOR SETUP menu. Run Manual Calibrate. Manually change the Gap/Mark Thresh and/or Paper Out Thresh values.
How to fix RIBBON OUT Load Ribbon error on SATO GL412e?
The SATO Barcode Reader indicates RIBBON OUT when the ribbon is broken between the ribbon rewind spindle and the print head or the ribbon supply is empty. To fix this, reattach the ribbon or load the printer with a new ribbon.
What does PRINTHEAD HOT Wait 5 Minutes Go Online mean on SATO GL412e?
The SATO Barcode Reader displays 'PRINTHEAD HOT' because the print head has become overheated. Allow the print head to cool down for 5 minutes, then press the Pause key to resume printing. If possible, reduce print intensity. If the problem persists, contact an authorized customer service representative.
What does DOWNLOADER ERROR FLASH WRITE #1 Repeat Download mean on SATO Barcode Reader?
The SATO Barcode Reader displays 'DOWNLOADER ERROR FLASH WRITE #1' because a Flash Write failed to complete. Try downloading again or contact an authorized customer service representative.
What does DOWNLOADER ERROR FLASH WRITE #4 Repeat Download mean on SATO GL412e Barcode Reader?
The SATO Barcode Reader displays 'DOWNLOADER ERROR FLASH WRITE #4' because a Flash Write failed to complete. Try downloading again or contact an authorized customer service representative.
Why does SATO GL412e Barcode Reader show ERROR: WRONG CHECKSUM Repeat Download?
The SATO Barcode Reader displays 'ERROR: WRONG CHECKSUM' because the printer received the complete program but the checksum did not match, indicating data corruption during download. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What to do when SATO GL412e Barcode Reader displays DOWNLOADER ERROR EXTERNAL FLASH IS FULL Optimize Files?
The SATO Barcode Reader displays 'DOWNLOADER ERROR EXTERNAL FLASH IS FULL' because an attempt was made to download to a full EFC. Delete and optimize files.
What causes EC SOFTWARE FAIL error on SATO Barcode Reader?
The SATO Barcode Reader displays 'EC SOFTWARE FAIL' due to engine control software failure. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What does FILE SYS WRITE Check Flash mean on SATO GL412e Barcode Reader?
The SATO Barcode Reader shows 'FILE SYS WRITE' because there is a problem writing to flash memory. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
General| Brand | SATO |
|---|---|
| Model | GL412e |
| Category | Barcode Reader |
| Language | English |
To Next Page
