Why is media calibration out of range for sensor detection on my SATO Barcode Reader?
If media calibration is out of range for sensor detection on your SATO Barcode Reader, ensure media is loaded correctly and the media sensor is located under the media.
What to do if my SATO TC408X says 'Memory full'?
If your SATO Barcode Reader shows 'Memory full', review the graphics and soft fonts sent from the host device. Use the application software to delete any that are no longer needed.
What to do if my SATO TC408X says 'Media out'?
If the SATO Barcode Reader displays 'Media out', you need to supply the media roll.
What to do if the media is uninstalled or used up in my SATO Barcode Reader?
If your SATO Barcode Reader shows 'Media is uninstalled or used up', load new media into the printer.
What to do if the ribbon is uninstalled or end-of-ribbon occurred in my SATO Barcode Reader?
If your SATO Barcode Reader shows 'Ribbon is uninstalled or end-of-ribbon occurred', load a new ribbon into the printer.
Why is my SATO TC408X Barcode Reader miss-detecting the gap, and how do I fix it?
If you encounter a 'Miss-detected gap' error with your SATO Barcode Reader, check the media path and the position of the label sensor. For continuous media, verify the application and driver settings, ensuring continuous media is selected.
What causes a 'Serial IO error' on my SATO TC408X Barcode Reader and how can I resolve it?
If your SATO Barcode Reader displays a 'Serial IO error', check the baud rate, format, or protocol settings between the host device and the printer to ensure they match.
What to do if the cutter failed on my SATO Barcode Reader?
If you are experiencing issues with the cutter on your SATO Barcode Reader, examine the media and the connection between the cutter and the main board.
How to fix a 'Ribbon sensor error' on my SATO TC408X Barcode Reader?
If your SATO Barcode Reader shows 'Ribbon sensor error', replace the ribbon sensor.
General| Brand | SATO |
|---|---|
| Model | TC408X |
| Category | Barcode Reader |
| Language | English |
Instructions for safely connecting the printer to a power source.
Detailed steps for preparing and loading media rolls into the printer.
Explanation of reflective and transmissive sensor types for media detection.
Procedure for installing ribbon rolls for thermal transfer printing mode.
Procedure for calibrating the label sensor to ensure accurate media detection.
Settings and functions of the DIP switches for printer configuration.
Procedure to restore the printer to its original factory default settings.
Step-by-step guide for installing the printer driver via USB connection.
Procedure for installing the printer driver for parallel or serial interfaces.
Interpreting LED blinking patterns to diagnose printer issues.
Solutions for common issues related to media detection and feeding.
Solutions for common issues related to ribbon installation and usage.
Detailed procedure for cleaning the printer's print head.
Procedure to clear paper jams from the rotary cutter.
Procedure to clear paper jams from the guillotine cutter.
To Next Page
