56
TC Series - User’s Manual
Printer Status
Printer is paused. Press PAUSE or CANCEL to
return to normal.
Media is uninstalled or used up. Load new
media to the printer.
Ribbon is uninstalled or end-of-ribbon
occurred. Load new ribbon to the printer.
Format or baud rate of RS232 communication
is inconsistent between printer and host.
Cutter cannot cut off the media, check media
and cutter.
Printer buffer full due to loaded soft fonts,
graphics or forms. Check data format. Call for
service.
Media calibration is out of range for sensor
detection. Make sure media is loaded and
media sensor locates under media.
Printing job will start until the temperature of
TPH goes down.
Print head latch is not closed. To print label the
head latch must be closed.
To Next Page
Loading...
