SATO TC408X - Guillotine Cutter with Paper Jam

80
TC Series - User’s Manual
Guillotine Cutter with Paper Jam
If there is paper jam inside guillotine cutter, check in Figure 2 and find
where the screw under guillotine cutter. It is to control cut actions of
guillotine cutter. Find a Phillips screwdriver to lay down the blade by
turning the screw as directions marked in the figures. Then paper can be
removed from the cutter.
Figure 1.
Figure 2.
Guillotine Cutter with full cut function: Turn counter-clockwise.
Guillotine Cutter with partial cut function: Turn clockwise.