6
TC Series - User’s Manual
1. Introduction
Proprietary Statement
This manual contains proprietary information of SATO CORPORATION. It is intended solely
for the information and use of parties operating and maintaining the equipment described
herein. Such proprietary information may not be used, reproduced, or disclosed to any
other parties for any other purpose without the expressed written permission of SATO
CORPORATION.
Product Improvements
Continuous improvement of products is a policy of SATO CORPORATION. All specifications
and signs are subject to change without notice.
Liability Disclaimer
SATO CORPORATION takes steps to assure that the company’s published engineering
specifications and manuals are correct; however, errors do occur. SATO CORPORATION
reserves the right to correct any such errors and disclaims any resulting liability. In no event
shall SATO CORPORATION or anyone else involved in the creation, production, or delivery of
the accompanying product (including hardware and software) be liable for any damages
whatsoever (including, without limitation, damages for loss of business profits, business
interruption, loss of business information, or other pecuniary loss) arising out of the use of
or the results of use of or inability to use such product, even if SATO CORPORATION has
been advised of the possibility of such damages.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
To Next Page
Loading...
Need help?
General
