SATO TC408X - Troubleshooting Printer Issues; LED Diagnosis; Media Problems

53
TC Series - User’s Manual
5. Troubleshooting
LED Diagnosis
Normally, if the printer is in not working properly, the "READY" LED blinks
continuously, and printing and communication between the host and
printer stops. Meanwhile, blinking LEDs indicate a problem. Check the LEDs
and refer to the following solutions suggested below.
Media Problems
LED
Indication
READY and MEDIA LEDs
Blinking
Possible Problems
Solutions
Remarks
Miss-detected gap
Check the media path.
Check the position of the
label sensor.
For continuous media,
check application and
driver, and select
continuous media.
Media out
Supply the media roll.
Media not installed
Install the media roll.
Media jam
Recover the jam.
Note: If problem continues, perform media calibration.