SATO TC408X - Ribbon Problems

54
TC Series - User’s Manual
Ribbon Problems
LED
Indication
READY and RIBBON LEDs
Blinking
Possible Problems
Solutions
Remarks
Ribbon out
Supply the ribbon roll
Not applicable to
direct thermal.
Ribbon jam
Recover the jam
Ribbon sensor error
Replace ribbon sensor
Note: If you use direct thermal, set by labeling software,
windows driver, printer commands, or DIP Switch.
Other Problems
LED
Indication
READY LED
Blinking
Problems
Solutions
Remarks
Serial IO error
Check the baud rate, format
or protocol between host and
printer.
Not for Centronics.