32
TC Series - User’s Manual
Printing a Configuration Report
Perform a self-test and print a configuration report, to check printer’s
print quality and internal settings.
Steps:
1. Turn off the printer. Load media and ribbon.
2. Press and hold the FEED/CONFIG. button while turning on the
printer.
3. When READY indicator starts to blink, release the
FEED/CONFIG. button. Printer now will print out a
configuration report.
4. Printer will enter Dump mode after printing configuration, if
it’s with SATO SEPL emulation. To return to normal operation
mode from Dump mode, press the CANCEL/RESET button.
Another way is to turn off printer power, and then restart
printer.
When the READY indicator stops blinking and remain
illuminated, printer is back in normal operation mode.
Note: In Dump mode, all characters will be printed in 2 columns:
the right shows characters received from your system, and the
left shows corresponding hexadecimal values of the characters.
It allows users or engineers to verify and debug the program.
To Next Page
Loading...
