57
TC Series - User’s Manual
Transmission Problems
If the host shows "Printer Time out"
1. Check if the communication cable (parallel or serial) is connected
securely to your parallel or serial port on the PC and to the
connector on the printer at the other end.
2. Check if the printer power is turned on.
If the data has been sent, but there is no output from the printer. Check
the active printer driver, and see if Seagull Driver for your Windows system
and the label printer has been selected.
Recovery
After correcting problems, simply press the CANCEL button or restart the
printer. Make sure the LEDs are not blinking and remember to resend your
files.
To Next Page
Loading...
