How to fix DOWNLOADER ERROR FLASH NOT ERASED Repeat Download on SATO GL412e Barcode Reader?
The SATO Barcode Reader displays 'DOWNLOADER ERROR FLASH NOT ERASED' because the printer encountered an error trying to program flash memory. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What causes DOWNLOADER ERROR MAIN FLASH IS FULL Optimize Files on SATO GL412e?
The SATO Barcode Reader displays 'DOWNLOADER ERROR MAIN FLASH IS FULL' because an attempt was made to download to a full main flash memory. Delete and optimize files.
What to do when SATO GL412e Barcode Reader displays DOWNLOADER ERROR EXTERNAL FLASH IS FULL Optimize Files?
The SATO Barcode Reader displays 'DOWNLOADER ERROR EXTERNAL FLASH IS FULL' because an attempt was made to download to a full EFC. Delete and optimize files.
Why does SATO GL412e Barcode Reader show ERROR: WRONG CHECKSUM Repeat Download?
The SATO Barcode Reader displays 'ERROR: WRONG CHECKSUM' because the printer received the complete program but the checksum did not match, indicating data corruption during download. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
How to fix INVALID FILE SYS Optimize&Reboot on SATO Barcode Reader?
The SATO Barcode Reader shows 'INVALID FILE SYS' because the file system was not detected or flash was corrupted. Enter the PRINTER SETUP menu and use the Optimize & Reboot option.
What does CALIBRATION FAIL mean on my SATO Barcode Reader?
The SATO Barcode Reader shows CALIBRATION FAIL because calibration values derived from Manual Calibrate were not acceptable. To fix this, perform a Run Manual Cal (run manual calibration) again.
Why does my SATO Barcode Reader display MEDIA OUT COMPATIBLE WITH CUTTER Check Media Mode?
The SATO Barcode Reader shows 'MEDIA OUT COMPATIBLE WITH CUTTER' because Tear-Off or Peel-Off Media Handling selection was attempted with the cutter option still installed. These modes require that the front door assembly be installed to use the Label Taken Sensor. Select a different Media Handling mode.
What does SOFTWARE ERROR Cycle Power mean on SATO Barcode Reader?
The SATO Barcode Reader shows 'SOFTWARE ERROR' because application software tried to perform an illegal power function or there are damaged logic circuits on the main circuit board. Cycle the printer’s power. If possible, print a job that has previously worked. If the problem persists, contact an authorized customer service representative.
Why am I getting ERROR: INSUFFICIENT FLASH on my SATO Barcode Reader?
The SATO Barcode Reader displays 'ERROR: INSUFFICIENT FLASH' because the printer requires more flash memory to download program. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What causes EC SOFTWARE FAIL error on SATO Barcode Reader?
The SATO Barcode Reader displays 'EC SOFTWARE FAIL' due to engine control software failure. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
General| Brand | SATO |
|---|---|
| Model | GL412e |
| Category | Barcode Reader |
| Language | English |
To Next Page
