Radio(s)
Radio Data System (RDS)
The audio system has a Radio Data
System (RDS). The RDS feature is
available for use only on FM stations
that broadcast RDS information.
This system relies upon receiving
specific information from these
stations and only works when the
information is available. While the
radio is tuned to an FM-RDS station,
the station name or call letters
displays. In rare cases, a radio
station can broadcast incorrect
information that causes the radio
features to work improperly. If this
happens, contact the radio station.
Playing the Radio
O (Power/Volume): Press to turn
the system on and off.
Turn to increase or decrease the
volume.
Finding a Station
BAND: Press to switch between
AM, FM, or XM™ (if equipped).
f (Tune): Turn to select radio
stations.
©SEEK ¨: Press to go to the
previous or to the next station.
To scan stations, press and hold
either arrow for a few seconds until
a beep sounds. The radio goes
to a station, plays for a few seconds,
then goes to the next station.
Press either arrow again to stop
scanning.
Radio with CD shown, Radio with Six-Disc CD similar
Instrument Panel 3-67
To Next Page
Loading...
Need help?
General
