Remote Keyless Entry
(RKE) System Operation
The Remote Keyless Entry (RKE)
transmitter functions work up to
195 feet (60 m) away from the
vehicle.
There are other conditions which
can affect the performance of the
transmitter. See Remote Keyless
Entry (RKE) System on page 2-3.
/ (Remote Vehicle Start):
For vehicles with this feature, this
button is used to operate the remote
start feature. See Remote Vehicle
Start on page 2-5 for additional
information.
Q (Lock): Press to lock all the
doors, including the liftgate.
K (Unlock): Press once to unlock
the driver door. If
K is pressed again
within five seconds, all remaining
doors unlock. The interior lamps
come on and stay on for 20 seconds
or until the ignition is turned on.
L (Vehicle Locator/Panic Alarm):
Press and release to locate the
vehicle. The turn signal lamps flash
and the horn sounds three times.
Press and hold
L to activate the
panic alarm. The turn signal lamps
flash and the horn sounds repeatedly
for 30 seconds. The alarm turns
off when the ignition is turned to
ON/RUN or when
L is pressed
again. The ignition must be in
LOCK/OFF for the panic alarm
to work.
Programming Transmitters
to the Vehicle
Only RKE transmitters
programmed to the vehicle
will work. If a transmitter is lost
or stolen, a replacement can be
purchased and programmed
through your dealer/retailer.
When the replacement transmitter
is programmed to the vehicle, all
remaining transmitters must also
be programmed. Any lost or stolen
transmitters no longer work once
the new transmitter is programmed.
Each vehicle can have up to eight
transmitters programmed to it.
See “Relearn Remote Key” under
DIC Operation and Displays on
page 3-42.
Without Remote Start Shown
(With Remote Start Similar)
2-4 Features and Controls
To Next Page
Loading...
Need help?
General
