Sauder 421952 - Page 21

å
Finish, fastening the TOP (L) to the ENDS (A and B). Use
two BUSHINGS (91M), WASHERS (13M), and BLACK
3/4" PAN HEAD SCREWS (85S) through the exact holes
shown in the LIFT TABLE MECHANISMS (23M) and into
the holes in the ENDS.
å
NOTE: Do not overtighten the SCREWS (85S).
Step 17
421952www.sauder.com/service
Page 21
If you're doing this to
help a friend, don't
leave without a bite.
23M
23M
L
Do not overtighten
the SCREWS (85S).
A
B
91M
91M
13M
13M
BLACK 3/4" PAN HEAD SCREW
(2 used for the BUSHINGS)
85S